KEYENCE LS-5000 - Manual (Page 35)

Chapter 6 Normal Mode
29
6
6.4 Setting Functions
Names and functions
Tag/Button Function Description Reference
page
DISPLAY HOLD Hold A measured value can be held or reset. 30
DATA ZERO Auto-zero A measured value can be instantaneously reset to “0.000”. 31
SCREEN Screen Selection The DISPLAY DATA screen or DISPLAY GRAPH screen 32 to 34
can be selected.
LIMIT SETUP Limit Setup 7 level tolerance limits can be set for each output. 35
CALIB Calibration Setup Minute measurement fluctuations caused by a change in the 36
target surface condition or target inclination can be corrected.
PROGRAM Program Selection Measurement data is stored and called as programs. 38
AREA Area Setup DIA, T.EDGE, B.EDGE or SEG(m,n) can be selected. 39
OUTPUT Calculation Setup Calculation can be performed with each measuring area 41
(A1 to A4).
Average Measurement results can be averaged. 44
M. Mode Nine measuring modes are provided. 46 to 53
Offset Any value can be added to or subtracted from the displayed 55
value.
Digit Sets the number of digits after the decimal point. 54
Analog Output An analog voltage (within ±10 V) proportional to the displayed 57
value can be output.
I/O Slot Setup Expansion I/O boards can be set. 59
INSPECT Inspect The scanning head conditions (optical axis, intensity) can 60
be checked.
UTILITY One-Scan Function Data obtained with only one surface of the 12-surface polygon 62
mirror becomes effective.
Program Selection The program selection method (front panel or rear terminals) 64
can be selected.
Display Unit The display units can be selected (“mm” or “inch”). 65
Area Check The number of edges in the measuring area can be 66
checked.
Initialize All settings are reset to the initial values. 67
Mode Change Normal mode or Pitch mode can be selected. 68
OPTIONS
LASER ON DISPLAY DATA NOR
MAL P. 1
OFF OFF
ZERO HOLD
SCREEN
DISPLAY
DATA
LIMIT
SETUP PROGRAM CALIB OPTIONS
Button
Tag