KEYENCE LK-G Series - Manual (Page 94)

3-36
3
LK-G-M-NO3-E
3 Function Settings
Outputting the Analog Output Without Holding
The internal measurement value before being retained is outputted when the analog-through is
set to ON while the measurement value is retained in the measurement mode.
■ Setting procedure of the analog-through
1
Hold down the key, and select " oUt-1 " with the
key.
OUT 1 is set in this example.
2
Press the key, and select function " " with the
key.
Set the analog-through.
3
Press the key, and select " -1 " with the key.
The analog output is output by through.
4
Press the key to register the setting. Press the
key to return to the measurement state.
If analog-through is set to ON, the offset value or the auto-zero value will not be reflected
to the analog output.
OUT1 HI GO LO
HI GO LO
TIM
OUT2 TIM
OUT1 HI GO LO
HI GO LO
TIM
OUT2 TIM
OUT1 HI GO LO
HI GO LO
TIM
OUT2 TIM
Note