KEYENCE LK-G Series - Manual (Page 76)

3-18
3
LK-G-M-NO3-E
3 Function Settings
Calculating Between the Heads
The surface displacement, thickness, and height-difference measurements can be performed
by calculating the data acquired from the setting of head A or head B according to the
measurement target.
■
Function Nos. and measurement examples
* Used in combination with the auto offset function.
When transparent object is selected for the measurement mode of head setting, head A and head B perform
surface measurement if
Add-Ab or Sub-Ab is selected.
■ Sub-functions and measurement surfaces
*When trAn-A is selected: ¤ =4, when tran-b is selected: ¤ =5
Function No. Calculation Function
A-0 a Head A Surface displacement measurement using the
head A or B
A-1 a Head B
A-2 add-ab Head A + B Thickness
measurement
using the head A
and B
A-3 sub-ab Head A - B Height-difference
measurement
using the head A
and B
A-4 tran-a Head-A transparent
object Performs the displacement measurement and
thickness measurement of the transparent object.
The measurement surface is selected by the sub-
function.
A-5 tran-b Head-B transparent
object
Sub-function Measurement surface Function
a- ¤ 0 1 1 Displacement measurement of
one surface
a- ¤ 1 2 2
a- ¤ 2 3 3
a- ¤ 3 4 4
a- ¤ 4 1-2 1-2 Measurement and calculation of
two phases
By selecting "4", the thickness of
the first sheet of glass can be
measured.
By selecting "7", the gap between
the first and the second sheets of
glass can be measured.
a- ¤ 5 1-3 1-3
a- ¤ 6 1-4 1-4
a- ¤ 7 2-3 2-3
a- ¤ 8 2-4 2-4
a- ¤ 9 3-4 3-4
Thickness measurement
Height
differe-
nce
measu-
rement
1
2
3
4
1
2
3
4