KEYENCE LK-G Series - Manual (Page 77)

3-19
3
LK-G-M-NO3-E
3 Function Settings
■ Setting procedure of the calculation between heads
1
Hold down the key, and select " oUt-1 " with the key.
2
Press the key, and select function " A " by the key.
Select the calculation.
3
Press the key, and select " A-2 " with the key.
The addition of head A and B is selected in the function.
4
Press the key to register the setting. Press the
key to return to the measurement state.
■
Setting procedure for measuring thickness of transparent target 1, 2 follow steps
1 & 2 from the previons section.
3
Press the key, and select " A-4 " with the key.
Head A’s transparent object is set in this example.
4
Press the key, and select " A-44 " with the key.
Measurement between surface ends 1 - 2 is selected in this
example.
5
Press the key to register the setting. Press the
key to return to the measurement state.
When [Transparent object 2] ( page 3-7) is specified, select the measurement surface
on which the object to be measured actually exists.
OUT1 HI GO LO
HI GO LO
TIM
OUT2 TIM
OUT1 HI GO LO
HI GO LO
TIM
OUT2 TIM
OUT1 HI GO LO
HI GO LO
TIM
OUT2 TIM
OUT1 HI GO LO
HI GO LO
TIM
OUT2 TIM
OUT1 HI GO LO
HI GO LO
TIM
OUT2 TIM
Note