KEYENCE LK-G Series - Manual (Page 18)

15 LK-G-M-NO0-E
List of Functions and Function Nos. .3-13
List of Default Values and Setting
Ranges ..........................................3-15
List of the OUT Setting Screens ....3-16
Calculating Between the Heads ....3-18
Setting the Scaling for Measurement
(Calibration)...................................3-20
Stabilizing the Measurement by
Filtering..........................................3-22
Using the Hold Function
(Measurement Mode) ....................3-25
Setting the Trigger Condition ........3-31
Measuring with Offset....................3-32
Setting the Unit and the Minimum
Display Unit ...................................3-33
Scaling the Analog Output ............3-34
Outputting the Analog Output Without
Holding ..........................................3-36
Setting the Common Function ............3-37
List of Functions and Function Nos.....3-37
List of Default Values and Setting
Ranges ..........................................3-37
List of the Common Function Setting
Screens .........................................3-38
Setting the Sampling Rate of
Measurement Value.......................3-39
Setting the Mutual Interference
Prevention Function.......................3-40
Setting the External Timing Input ..3-41
Setting the Output Form of the
Tolerance Comparator ..................3-42
Setting the Strobe Output Time .....3-43
Accumulating the Measurement Value in the
Memory (Data Storage Function) .......3-44
Setting the Operations of the Equipment
(Environment Settings) .......................3-46
List of Functions and Function Nos.....3-46
List of Default Values and Setting
Ranges ..........................................3-47
List of the Environment Setting Screens
.......................................................3-48
Setting the Communication
Specifications of the RS-232C...... 3-49
Setting the Program Switching Method
...................................................... 3-50
Copying/Initializing the Program .. 3-51
Preventing Erroneous Operation on the
Panel (Panel Lock) ....................... 3-53
Reducing the Power Consumption
(Eco Mode) ................................... 3-54
Chapter 4 Input/Output Terminals
Identifying Names and Functions of the
Input/Output Terminals ........................ 4-2
Functions of the Input/
Output Terminals ............................ 4-2
Functions of the Input and Output
Signals ............................................ 4-7
Timing Chart ...................................... 4-13
Chapter 5 RS-232C
Specifications ...................................... 5-2
Pin Layout ....................................... 5-2
Communication Specifications ....... 5-2
Communication Performance and
Communication Mode in the
Measurement State ........................ 5-3
Overview of the Settings According to
External Devices............................. 5-3
Outputting Measurement Values and
Changing Settings through Commands .... 5-4
Connecting the PC or PLC Link Unit5-4
Mode Change Command ............... 5-7
Measurement Control Command
Format ............................................ 5-8
Change Parameter Command ..... 5-13
Check Parameter Command Format.. 5-20
Timing Chart ................................. 5-21
Outputting Measurement Values in External
Synchronization ................................. 5-22
Environment Settings Parameters ... 5-22