KEYENCE LK-G Series - Manual (Page 194)

A-10 LK-G-M-NOA-E
Output Format .....................................5-24
P
Package Contents .................................1-3
Panel lock ............................................3-53
Peak hold.......................... 3-25, 3-28, 4-14
Peak-to-peak hold ........... 3-25, 3-28, 4-14
Program Switching ..............................3-50
Program Function ..................................2-8
Program No. change time ...................4-18
Program No. switch input ......................4-7
R
Refresh rate .........................................4-17
RESET time..........................................4-17
Response Delay Time .........................6-17
Returning the LK-Series to the Factory
Default Settings ...................................1-26
Reference rate.....................................4-18
RS-232C ................................................5-1
RS-232C connector ...............................1-7
S
Sample hold ..................... 3-25, 3-30, 4-14
Sampling rate ......................................3-39
Scaling (Calibration) ...........................3-20
Scaling the Analog Output ..................3-34
Sensor (emitter) ....................................1-8
Sensor (receiver) ..................................1-8
Separate type controller ........................1-3
Separating the single unit type
controller..............................................1-19
Setting mode .......................................1-25
Setting procedure of numerical
values ....................................................2-4
Setting the Measurement Mode ...........3-7
Setting the mounting mode ................3-12
Setting the Tolerance Comparator
Value .....................................................2-3
Setting value format ..............................5-6
Single display ........................................2-2
Single unit type controller ..................... 1-3
Specifications ....................................... 6-2
Specifications of the Controller............. 6-2
Specifications of the Head ................... 6-4
Spot diameter ....................................... 6-4
Statistical computation ....................... 2-10
Status Table ........................................ 6-15
Strobe output time .............................. 3-43
Switching Modes ................................ 1-24
Switching Program Nos. ...................... 2-9
Switching the Measurement
Value Displays ...................................... 2-2
System Configuration ........................... 1-2
T
Thickness measurement..................... 3-18
Timing Chart ...................................... 4-13
Timing synchronization....................... 3-41
Translucent object ................................ 3-7
Transparent object................................ 3-7
Transparent object 2............................. 3-7
Trigger Condition ................................ 3-31
Troubleshooting ................................... A-2
U
USB connector ..................................... 1-7
V
Voltage input....................................... 4-11
W
Warning labels..........................................7