KEYENCE LK-G Series User Manual

Page 43

1-23

LK-G-M-NO1-E

1 Before Use

■

Connecting the display panel

In the case of the separate type controller, the display panel cable is used for connecting the
controller to the display panel.

The LK-G series can be operated without the display panel. In addition, the operation from
a PC is possible by using the "LK-Navigator" software.

■

Connecting the power

Connect the 24V DC power to the terminals 1 and 2 of the 12-pin terminal block.

KEYENCE CA-U3 is recommended for the 24V DC power supply.

■

Connecting the terminal block

The steps to connect the wires to the terminal block are as follows:

Remove the terminal block from the controller.

Loosen the two screws with a screwdriver and pull it out.

Loosen the screws on the terminal with a screwdriver, and insert the lead wires

into the terminal block.

Approximately 6.5mm of the insulation should be striped from both wires.

Tighten the lead wires with the screwdriver.

After tightening them, pull the lead wires lightly to confirm that they are securely

fixed.

Install the terminal block to the controller.

Reference