Setting the strobe output time, Setting the strobe output time -43 – KEYENCE LK-G Series User Manual
Page 101
3-43
3
LK-G-M-NO3-E
3 Function Settings
Setting the Strobe Output Time
The period of time for the strobe output to turn ON (one-shot output time) can be set.
The pulse width can be selected from the following four types.
■
Setting procedure of the pulse width of the strobe signal
1
Hold down the
key, and select "
oPt on
" with the
key.
Set the common settings.
2
Press the
key, and select function
"
E
" with the
key.
The pulse width of the strobe signal is set.
3
Press the
key, and select
"
E-2
" with the
key.
Set the pulse width to “10” ms.
4
Press the
key to register the setting. Press the
key to return to the measurement state.
If the Measurement Mode is set to normal, the strobe signal is output for the specified
period only when the measurement value is held. If the measurement value is not held, the
strobe signal is output for half the period of sampling cycle.
Function No.
Function (Strobe output time)
E-0
2
2 ms
E-1
5
5 ms
E-2
10
10 ms
E-3
20
20 ms
Refer to "Timing Chart" (4-13 page) for the timing chart.
Refer to "Binary output" (4-16 page) for details of binary output.
OUT1
HI
GO
LO
HI
GO
LO
TIM
OUT2
TIM
OUT1
HI
GO
LO
HI
GO
LO
TIM
OUT2
TIM
OUT1
HI
GO
LO
HI
GO
LO
TIM
OUT2
TIM
Note