KEYENCE LK-G Series - Manual (Page 45)

1-25
1
LK-G-M-NO1-E
1 Before Use
Setting Mode
In the Setting mode, every time the key is pressed, the setting content advances in this
order : Head Setting → OUT Settings → Common Settings → Environment Settings.
PROG.0 to 7
Eight programs can be switched among Program Nos. 0 to 7 in the LK-G Series. You can register a set of
parameters as a program according to the measurement process or the measuring target. The set parameters
can easily be changed, if necessary, when calling up the desired program.
Head setting : The functions regarding sensing for stable detection can be set.
Setting contents : ABLE, Measurement mode, ALARM warning, ABLE calibration
Refer to "Setting the Head" (page 3-3).
OUT settings: The functions regarding data processing can be set.
Setting contents : Calculation method, Scaling, Filter, Measurement mode, Trigger, Offset, Minimum
display unit, Analog scaling, Analog through
Refer to "Setting the Conditions of Measurement Value Output" (page 3-13).
Common settings : The common functions regarding the head setting and the OUT setting can be set.
Setting contents : Sampling rate, Mutual interference prevention, Timing synchronization, Comparator
output format, Strobe time, Data storage
Refer to "Setting the Common Settings" (page 3-37).
Environment settings : The operating environment of the LK-G series can be set.
Setting contents :
RS-232C, Setting selection, Program, Panel lock, Eco mode
Refer to "Setting the Operations of the Equpement (Enviroment Settings)" (page 3-46).
OUT1 HI GO LO
HI GO LO
TIM
OUT2 TIM
OUT1 HI GO LO
HI GO LO
TIM
OUT2 TIM
OUT1 HI GO LO
HI GO LO
TIM
OUT2 TIM
OUT1 HI GO LO
HI GO LO
TIM
OUT2 TIM
key
OUT1 HI GO LO
HI GO LO
TIM
OUT2 TIM
OUT1 HI GO LO
HI GO LO
TIM
OUT2 TIM
Environment Settings
Common Settings
key
key
key
key
OUT Settings
Head Settings
key
PROG.0 to 7