Cub Cadet 8404 User Manual
Page 227

STEERING SYSTEM
8-17
D615-W02 May-2003
615W824A
615W823A
615W822A
7. Disassemble GEROTOR. Make sure rotor not
dropped from outer ring of GEROTOR.
8. Pull out spacer plate (8) and O-ring (9).
9. Pull out driver (11).
10. Pull out O-ring from housing.
11. Push inside spline of spool by the thumb and pull
out spool and sleeve assembly from the opposite
side of the housing flange. This time, make sure
sleeve O.D. is not seized with into housing I.D.
12. Pull out pin (13) from spool and sleeve assembly.
(8) Plate
(11) Driver
(9) O-Ring
13. Push spool of sleeve forward and disassemble
center spring from spool by hand. Pull out sleeve
from spool. Rotate and pull out sleeve carefully.
14. Pull out two bearing less (18), needle bearing (19)
and retainer ring (17). Always insert needle bear-
ing between bearing less.
(17) Retainer Ring
(18) Bearing Less
(19) Needle Bearing
•
Centering spring can be protrude from
spool, so always wear safety goggle.
CAUTION
(1) Position Alignment Mark
(2) Pin