Rice Lake PR5230 Fieldbus Transmitter - Manual (Page 115)

PR 5230 Instrument Manual Commissioning
Sartorius EN-115
5.4.5 Determining the Dead Load
Note: If the liniarization is active (see Chapter 5.4.10):
After selection of the line ‚Dead load at’ the following tip is displayed:
Can not be changed here
while linearization is active
Weighingpoint/WP A/ Calibration
Max 3000 d 3000 kg
Scale interval 3000 d 1 kg
Deadload at 0.00 kg 0.000000
Max at 3000.00 kg 1.000000
Not calibrated
Sensitivity 833.33 4.000000
by load by mV/V CalcTest
To use the empty scale/hopper as dead load (normal case):
• discharge the scale/hopper.
• press [by load].
After
or confirmation of the change is displayed:
Set deadload
If the mV/V value of the dead load was calculated, or if it is known from the previous calibration, the value can
be overwritten by pressing [by mV/V].
Weighingpoint/WP A/ Calibration
Max 3000 d 3000 kg
Scale interval 3000 d 1 kg
Deadload at 0.00 kg 0.000000
Max at 3000.00 kg 1.000000
Calibrated at 3000.00 kg 1.000000
Sensitivity 833.33 4.000000
by load by mV/V CalcTest