Dell PowerVault MD3260i - Manual (Page 295)

Parameters
Parameters Description
snapVirtualDisk The alphanumeric identifier (including - and _) of the
snapshot virtual disk for which you are setting properties.
Enclose the snapshot virtual disk identifier in double
quotation marks (" ") inside of square brackets ([ ]).
repositoryFullLimit The percentage of repository virtual disk capacity at
which you receive a warning that the snapshot repository
virtual disk is nearing full. Use integer values. For example,
a value of 70 means 70 percent. The default value is 75.
repositoryVirtualDisk The alphanumeric identifier of the repository virtual disk
has the snapshot image. All repository identifiers have this
form: repos_xxxx where xxxx represents a four digit
numerical value. Enclose the snapshot virtual disk name in
double quotation marks (" ").
count The number of repository virtual disks that you want to
remove from the snapshot group. Use integer values.
Notes
When you use this command, you can specify only one of the parameters. You cannot enter more than one parameter
when you run this command.
Set Storage Array
Description
This command defines the properties of the storage array.
Syntax
set storageArray autoSupportConfig (enable | disable) |
cacheBlockSize=cacheBlockSizeValue |
cacheFlushStart=cacheFlushStartSize |
cacheFlushStop=cacheFlushStopSize |
defaultHostType=(“hostTypeName” |
hostTypeIdentifier)
failoverAlertDelay=delayValue |
mediaScanRate=(disabled | 1-30) |
password=”password” |
userLabel=”storageArrayName”)
isnsRegistration=(TRUE | FALSE)
295