Dell PowerVault MD3260i - Manual (Page 296)

Parameters
Parameter Description
autoSupportConfig The setting for automatically collecting support data each time the
firmware detects a critical MEL event. This parameter has these
values:
• enable—Turns on the collection of support data
• disable—Turns off the collection of support data
cacheBlockSize The cache block size that is used by the RAID controller module for
managing the cache. Valid values are 4 (4 KB), 8 (8 KB), 16 (16
KB), or 32 (32 KB).
cacheFlushStart The percentage of unwritten data in the cache that causes a
cache flush. Use integer values from 0 to 100 to define the
percentage. The default value is 80.
cacheFlushStop The percentage of unwritten data in the cache that stops a cache
flush in progress. Use integer values from 0 to 100 to define the
percentage. This value must be less than the value of the
cacheFlushStart parameter.
defaultHostType The default host type of any unconfigured host port to which the
RAID controller modules are connected. To generate a list of valid
host types for the storage array, run the show storageArray
hostTypeTable command. Host types are identified by a name
or a numerical index. Enclose the host type name in double
quotation marks (“ ”). Do not enclose the host type numerical
identifier in double quotation marks.
failoverAlertDelay The failover alert delay time in minutes. The valid values for the
delay time are 0 to 60 minutes. The default value is 5.
mediaScanRate The number of days over which the media scan runs. Valid values
are disabled, which turns off the media scan, or 1 day to 30
days, where 1 day is the fastest scan rate, and 30 days is the
slowest scan rate. A value other than disabled or 1 to 30 does
not allow the media scan to function.
password The password for the storage array. Enclose the password in
double quotation marks (“ ”).
userLabel The name for the storage array. Enclose the storage array name in
double quotation marks (“ ”).
isnsRegistration The method to register the iSCSI target with the iSNS server. Set
the parameter to TRUE to enable registration. Set the parameter to
FALSE to disable registration.
296