Dell PowerVault MD3260i - Manual (Page 355)

Start Remote Replication Synchronization
Description
This command starts Remote Replication synchronization.
Syntax
start asyncRemoteReplicationGroup ["asyncRemoteReplicationGroupName"]
synchronize
Parameter
Parameter Description
asyncRemoteReplicationGroup The name of the remote replication group for which you
want to start synchronization. Enclose the remote
replication group name in square brackets ([ ]). If the
remote replication group name has special characters,
you also must enclose the remote replication group name
in double quotation marks (" ") inside square brackets. If
the remote replication group name consists only of
numbers, such as "1002," you also must enclose the
remote replication group name in double quotation marks
(" ") inside square brackets.
Start Remote Replication (Legacy) Synchronization
Description
NOTE: This command valid only with Fibre Channel storage arrays.
This command starts Remote Replication (legacy) synchronization.
Syntax
start remoteReplication primary
[”virtualDiskName”] synchronize
Parameters
Parameter Description
primary The name of the primary virtual disk for which you want to
start synchronization. Enclose the primary virtual disk
name in double quotation marks (“ ”) inside square
brackets ([ ]).
355