Dell PowerVault MD3260i - Manual (Page 378)

Parameters
Parameter Description
asyncRemoteReplicationGroup The name of an existing remote replication group that you
want to test. Enclose the remote replication group name in
square brackets ([ ]). If the remote replication group name
has special characters, you also must enclose the remote
replication group name in double quotation marks (" ").
testID The identifier for the diagnostic test you want to run. The
identifier and corresponding tests are as follows:
• All—Performs all the tests associated with this
command.
• Connectivity—Verifies that the two RAID
controller modules have a communication path.
The connectivity test sends an inter-RAID
controller module message between the storage
arrays, and then validates that the corresponding
remote replication group on the remote storage
array exists. It also validates that the virtual disk
members of the remote replication group on the
remote system match the virtual disk members of
the remote replication group on the local system.
• Latency—Sends a SCSI test unit command to
each virtual disk on the remote storage array
associated with the remote replication group to
test the minimum, average, and maximum latency.
• Bandwidth—Sends two inter-RAID controller
module messages to the remote storage array to
test the minimum, average, and maximum
bandwidth as well as the negotiated link speed of
the port on the RAID controller module performing
the test.
• Port connections—Shows the port that is
being used for replicating on the local storage
array and the port that is receiving the replicated
data on the remote storage array.
Validate Storage Array Security Key
Description
This command validates the security key for a storage array that has self-encrypting disk physical disks to make sure
that the security key is not corrupt.
Syntax
validate storageArray securityKey
file="fileName"
passPhrase="passPhraseString"
378