Dell PowerVault MD3260i - Manual (Page 351)

Parameters
Parameter Description
diskPool The alphanumberic identifier of the disk pool (including –
and _) that you want to locate. Enclose the
diskPoolName
in square brackets ([ ]).
Start Enclosure Blink
Description
This command identifies an enclosure by turning on the indicator LED. (Use the stop enclosure blink command
to turn off the indicator LED for the enclosure.)
Syntax
start enclosure [enclosureID] blink
Parameters
Parameter Description
enclosure Identifies the enclosure to blink. Enclosure ID values are 0
to 99. You must put brackets ([ ]) around the enclosure ID
value.
Start iSCSI DHCP Refresh
Syntax
start controller [(0 | 1)] iscsiHostPort [(1 | 2 | 3 | 4)] dhcpRefresh
Parameters
Parameter Description
controller The identifier letter of the RAID controller module that has
the iSCSI host ports. Valid RAID controller module
identifier values are 0 or 1, where, 0 is the RAID
controller module in slot 0, and 1 is the RAID controller
module in slot 1.
iscsi-host-port The identifier of the port on the storage array on which
you want to refresh the DHCP parameters. Enclose the
iSCSI host port name in square brackets ([ ]).
351