Dell PowerVault MD3260i - Manual (Page 248)

Revive Physical Disk
Description
This command forces the specified physical disk to the optimal state.
CAUTION: Correct use of this command depends on the data configuration on all physical disks in the disk group.
Never attempt to revive a physical disk unless supervised by a Technical Support representative.
Syntax
revive physicalDisk [enclosureID,slotID]
Parameter
Parameter Description
physicalDisk Identifies the enclosure and slot where, the physical disk
resides. Enclosure ID values are 0 to 99. Slot ID values
are 0 to 31. You must put brackets ([ ]) around the
enclosure ID value and the slot ID value.
Revive Snapshot Group
Description
This command forces the specified snapshot group to the Optimal state. If the snapshot group is not in a Failed state, the
firmware displays an error message and does not run this command.
Syntax
revive snapGroup [snapGroupName]
Parameter
Parameter Description
snapGroup The alphanumeric identifier (including - and _) of the
snapshot group that you want to set to the Optimal state.
Enclose the snapshot group identifier in square brackets
([ ]).
248