Dell PowerVault MD3260i - Manual (Page 72)

virtualDisk command to stop the copy
‑on‑write operations. When you stop a snapshot virtual disk, the snapshot
virtual disk and the repository virtual disk are still defined for the source virtual disk; only copy-on-write has stopped.
The following example stops a snapshot virtual disk:
client>smcli 123.45.67.89 -c "stop snapshot
virtualDisks [\"Mars_Spirit_4-2\" \"Mars_Spirit_4-3\"];"
The following example is the script file version of the command:
stop snapshot virtualDisks ["Mars_Spirit_4-2"
"Mars_Spirit_4-3"];
When you stop the copy-on-write operations for a specific snapshot virtual disk, only that snapshot virtual disk is
disabled. All other snapshot virtual disks remain in operation.
Re-creating The Snapshot Virtual Disk
To restart a copy-on-write operation, use the recreate snapshot virtualDisk command. This command
starts a fresh copy-on-write operation using an existing snapshot virtual disk. When you restart a snapshot virtual disk,
the snapshot virtual disk must have either an Optimal or a Disabled state. The following conditions then occur:
• All copy-on-write data previously on the snapshot repository virtual disk is deleted.
• Snapshot virtual disk and snapshot repository virtual disk parameters remain the same as the previously
disabled snapshot virtual disk and snapshot repository virtual disk. You can also change the userLabel,
warningThresholdPercent, and repositoryFullPolicy parameters when you restart the
snapshot virtual disk.
• The original names for the snapshot repository virtual disk are retained.
Preparing Host Servers To Re-create A Snapshot Virtual Disk
CAUTION: Before you create a new point-in-time image of a source virtual disk, stop any data access (I/O) activity
or suspend data transfer to the source virtual disk and snapshot virtual disk to ensure that you capture an accurate
point-in-time image of the source virtual disk. Close all applications, including Windows Internet Explorer, to make
sure all I/O activity has stopped.
NOTE: Removing the drive letter of the associated virtual disk in Windows or unmounting the virtual drive in Linux
helps to guarantee a stable copy of the drive for the Snapshot.
Before re-creating a snapshot virtual disk, both the server and the associated virtual disk you are re ‑creating have to be
in the proper state. To ensure that the host server is properly prepared to re-create a snapshot virtual disk, you can
either use an application to carry out this task, or you can perform the following steps:
1. Stop all I/O activity to the source and snapshot virtual disk (if mounted).
2. Using your Windows system, flush the cache to both the source and the snapshot virtual disk (if mounted). At the
host prompt, type SMrepassist ‑f and press . See "SMrepassist
Utility" in the Owner’s Manual for more information.
3. Remove the drive letter(s) of the source and (if mounted) snapshot virtual disk in Windows or unmount the virtual
drive(s) in Linux to help guarantee a stable copy of the drive for the Snapshot. If this is not done, the snapshot
operation reports that it has completed successfully, but the snapshot data is not updated properly.
4. Follow any additional instructions for your operating system. Failure to follow these additional instructions can
create unusable snapshot virtual disks.
NOTE: If your operating system requires additional instructions, you can find those instructions in your
operating system documentation.
After your server has been prepared, see Re-creating The Snapshot Virtual Disk to re-create the snapshot virtual disk.
72