Dell PowerVault MD3260i - Manual (Page 362)

Start Virtual Disk Initialization
Description
This command starts the formatting of a virtual disk in a storage array.
NOTE: Initializing a virtual disk is a long-running operation that you cannot stop.
Syntax
start virtualDisk [virtualDiskName] initialize
Parameters
Parameter Description
virtualDisk Name of the virtual disk for which to start the formatting.
You must put brackets ([ ]) around the virtual disk name. If
the virtual disk name has special characters, you must
also put quotation marks (" ") around the virtual disk name.
Stop Configuration Database Diagnostic
Description
This command stops the diagnostic test to validate the configuration database in the controller firmware that was
started by the start storageArray configDbDiagnostic command.
Syntax
Stop storageArray configDbDiagnostic
Parameters
None.
NOTE: The controller firmware returns a confirmation that the diagnostic test was cancelled. In addition, the
database configuration diagnostic test can be started through the storage management software GUI but cannot
be stopped through the storage management software GUI. If you want to stop a running diagnostic test, you must
use the stop storageArray configDbDiagnostic command.
Stop Consistency Group Snapshot Rollback
Description
This command stops a rollback operation to the member base virtual disks in a snapshot consistency group that was
initiated by the start rollback cgSnap command.
362