beautypg.com

Dell PowerVault MD3260i User Manual

Page 284

background image

Parameter

Description

previous update. You can specify the length of time in
minutes, hours, or days.

NOTE: You must set the Recovery Point Threshold to
be twice as large as the synchronization interval
threshold.

warningThresholdPercent

Specify the percent value that determines when a warning
is triggered when the capacity of a replication repository
virtual disk reaches the defined percentage. Define the
threshold by percentage (%) of the capacity remaining.

userLabel

The new name that you want to give to the remote
replication group. Use this parameter when you want to
rename the remote replication group. Enclose the new
remote replication group name in double quotation marks
(" ").

autoResync

The settings for automatic resynchronization between the
primary virtual disks and the secondary virtual disks of a
remote replicated pair within a remote replication group.
This parameter has these values:

enabled—Automatic resynchronization is

turned on. You do not need to do anything further

to resynchronize the primary virtual disk and the

secondary virtual disk.

disabled—Automatic resynchronization is

turned off. To resynchronize the primary virtual

disk and the secondary virtual disk, you must run

the resume remoteReplicationGroup

command.

virtualDisk

The name of the specific virtual disk that you want to
modify in the remote replication group. Enclose the virtual
disk name in double quotation marks (" ").

repositoryVirtualDisk

The name of the repository virtual disk for which you want
to increase capacity. An available standard virtual disk is
added to the repository virtual disk to increase the
capacity of the repository virtual disk.
You have two options for defining the name of a repository

virtual disk:

Use an existing repository virtual disk name.

Create a new repository virtual disk when you run

this command.

The name of an existing repository virtual disk is

comprised of two parts:

The term repos

A four digit numerical identifier that you assign to

the repository virtual disk name.

284