Dell PowerVault MD3260i - Manual (Page 272)

Host Group Parameter Host Has Individual Virtual Disk-to-
LUN Mappings
Host Does Not Have Individual Virtual
Disk-to-LUN Mappings
defaultGroup The command fails. The host is removed from the present
host group and is placed under the
default group.
NOTE: When you use this command, you can specify one or more of the optional parameters. You do not, however,
need to use all of the parameters.
NOTE: You can use any combination of alphanumeric characters, hyphens, and underscores for the names.
Command names can have a maximum of 30 characters. If you exceed the maximum character limit, replace
square brackets ([ ]) with angle brackets (< >) to overcome this limitation.
Set Host Channel
Description
This command defines the loop ID for the host channel.
Syntax
set hostChannel [hostChannelNumber]
preferredID=portID
Parameters
Parameter Description
hostChannel The identifier number of the host channel for which you
want to set the loop ID.
The host channel identifier number is constructed by
combining the controller number and the host channel
number. Enclose the host channel identifier number in
square brackets ([ ]). Separate the controller number from
the host channel number with a comma.
For example, the identifier number for host channel 2 on
controller 0 would be [0,2].
preferredID The port identifier for the specified host port. Port ID
values are 0 to 127.
Set Host Group
Description
This command renames a host group.
272