Dell PowerVault MD3260i - Manual (Page 361)

NOTE: Executing a consistency check with the diagnosticType parameter set to a value other than
filesystem, and with the sourceLocation parameter set to onboard, can cause the operation to run for
a long time. This can have adverse effects on host I/O processing. This operation should be done only under
direction from the support organization.
Upon completion of the diagnostic test, the controller firmware returns one of these results:
• Diagnosis completed without errors. No ZIP file created.
• Diagnosis completed with errors. Refer to the ZIP file created at:
...\Install_dir\data\FirmwareUpgradeReports\timestamp_buildNo.zip
If the diagnostic test detects an inconsistency in the configuration database, the RAID controller module firmware
performs these actions:
• Returns a description of the inconsistency
• Saves a ZIP file containing raw binary data
The RAID controller module firmware saves the ZIP file to this location:...\Install_dir\data\FirmwareUpgradeReports
\timestamp_buildNo.zip
You can use the binary data to help determine the cause of the problem, or you can send the file containing the binary
data to a Technical Support representative.
To stop the database configuration diagnostic test, use the stop storageArray configDbDiagnostic
command.
In addition, you can start the database configuration diagnostic test through the storage management software GUI;
however, you cannot stop the database configuration diagnostic test through the storage management software GUI. If
you want to stop a running diagnostic test, you must use the stop storageArray configDbDiagnostic
command.
Start Storage Array iSCSI Refresh
Description
This command initiates a refresh of the network address information for the iSNS server. If the DHCP server is marginal
or unresponsive, the refresh operation can take from 2 to 3 minutes to complete.
NOTE: This command is for IPv4 only.
Syntax
start storageArray isnsServerRefresh
Parameters
None.
NOTE: If you used the set storageArray isnsIPv4ConfigurationMethod command to set the
configuration but did not set the configuration to DHCP, running the start storageArray
isnsServerRefresh returns an error.
361