Dell PowerVault MD3260i - Manual (Page 283)

Set Remote Replication Group
Description
Use this command to change the synchronization settings and warning thresholds that the RAID controller module
owner of the primary side of the remote replication group uses when it performs an initial synchronization or
resynchronization. Changing the synchronization settings affects the synchronization operations of all replicated pairs
within the remote replication group.
Syntax
set asyncRemoteReplicationGroup ["asyncRemoteReplicationGroupName"]
[syncInterval=integer (minutes | hours | days)
warningSyncThreshold=integer (minutes | hours | days)
warningRecoveryThreshold=integer (minutes | hours | days)
warningThresholdPercent=percentValue
userLabel="New_remoteReplicationGroupName"
autoResync=(TRUE | FALSE)
virtualDisk="virtualDiskName" increaseRepositoryCapacity
(repositoryVirtualDisk="repos_xxxx" |
repositoryVirtualDisk=(diskGroupName [capacity=capacityValue])
repositoryVirtualDisk=(diskPoolName [capacity=capacityValue]))
role=(primary|secondary) ([force=TRUE|FALSE]|[noSync=TRUE|FALSE])
Parameters
Parameter Description
asyncRemoteReplicationGroup The name of the remote replication group that you want to
modify. Enclose the virtual disk name in square brackets
([ ]). If the virtual disk name has special characters, you
also must enclose the virtual disk name in double
quotation marks (" ") inside square brackets. If the virtual
disk name consists only of numbers, such as "1002," you
also must enclose the virtual disk name in double
quotation marks (" ") inside square brackets.
syncInterval Specify the length of time between automatically sending
updates of modified data from the local storage array to
the remote storage array. You can specify the length of
time in minutes, hours, or days.
warningSyncThreshold Specify the length of time to wait until a warning is
triggered for cases in which the synchronization of all of
the virtual disks within the remote replication group takes
longer than the defined time. You can specify the length of
time in minutes, hours, or days.
warningRecoveryThreshold Specify the length of time to wait until a warning is
triggered when the automatic data update for the point-in-
time image on the remote storage array is older than the
defined time. Define the threshold from the end of the
283