Show raid controller module, Parameters, Description – Dell PowerVault MD3260i User Manual
Page 322: Syntax
Parameters
None.
NOTE: When all firmware downloads have successfully completed, this command returns a Successful status.
If any firmware downloads fail, this command shows the firmware download status of each targeted physical disk.
This command returns the status values shown in the following table.
Status
Definition
Successful
Downloads completed without errors.
Not Attempted
Downloads did not start.
Partial Download
Downloads are in progress.
Failed
Downloads completed with errors.
Show RAID Controller Module
Description
For each RAID controller module in a storage array, this command returns the following information:
•
Status (Online, Offline)
•
Current firmware and NVSRAM configuration
•
Pending firmware and NVSRAM configuration configurations (if any)
•
Board ID
•
Product ID
•
Product revision
•
Serial number
•
Date of manufacture
•
Date and time to which the RAID controller module is set
•
Associated virtual disks (including preferred owner)
•
Ethernet port
•
Physical disk interface
Syntax
show (allControllers | controller [(0 | 1)]) [summary]
Parameters
Parameter
Description
allControllers
Returns information about both RAID controller modules in
the storage array.
controller
Returns information about a specific RAID controller
module in the storage array. Valid RAID controller module
322