Dell PowerVault MD3260i - Manual (Page 170)

enclosureLossProtect=(TRUE | FALSE)
drawerLossProtect=(TRUE | FALSE)
dssPreAllocate=(TRUE | FALSE)
securityType=(none | capable | enabled)]
Parameters
Parameter Description
physicalDisks Specifies the physical disks to assign to the created
virtual disk. Specify the enclosure ID and slot ID for each
unassigned physical disk to assign to the virtual disk.
Enclosure ID values are 0 to 99. Drawer ID values are 0
to 4. Slot ID values are 0 to 31. You must put parentheses
around the enclosure ID values and the slot ID values.
diskGroupUserLabel The alphanumeric identifier (including – and _) that you
want to give the new disk group. Enclose the disk group
identifier in square brackets ([]).
raidLevel RAID level of the disk group that contains the virtual disk.
Valid values are 0, 1, 5, or 6.
NOTE: If you set the raidLevel parameter to RAID
1, the RAID controller module firmware takes the list
of physical disks and pairs them using the following
algorithm:
Data physical disk =
X
Consistency physical disk = N / 2 + X
where, X goes from 1 to N / 2 and N is the number of
physical disks in the list. The following data show an
example of six physical disks and their mirror pairs.
Data Consistency
1 N / 2 + 1 = 4
2 N / 2 + 1 = 5
3 N / 2 + 1 = 6
userLabel Name that you want to give the new virtual disk. You must
put quotation marks (" ") around the new virtual disk name.
NOTE: You can use any combination of alphanumeric
characters, hyphens, and underscores for the names.
Spaces are not allowed. Names can have a maximum
of 30 characters.
capacity Size of the virtual disk that you are adding to the storage
array. Size is defined in units of bytes, KB, MB, GB, or TB.
170