Dell PowerVault MD3260i - Manual (Page 144)

Parameters
Parameter Description
virtualDisk Name of the specific virtual disk to check consistency.
You must put brackets ([ ]) around the virtual disk name. If
the virtual disk name has special characters, you must
also put quotation marks (" ") around the virtual disk name.
consistencyErrorFile Name of the file in which to save the consistency error
information. You must put quotation marks (" ") around the
file name.
mediaErrorFile Name of the file in which to save the media error
information. You must put quotation marks (" ") around the
file name.
priority Specifies the priority that the consistency check has
relative to host I/O activity. Valid entries are highest,
high, medium, low, or lowest.
startingLBA The starting logical block address. Use integer values.
endingLBA The ending logical block address. Use integer values.
verbose Captures progress details, such as percent complete, and
shows the information while virtual disk consistency is
being repaired. To capture progress details, set this
parameter to TRUE. To prevent capturing progress
details, set this parameter to FALSE.
NOTE: The starting logical block address and the ending logical block address are useful for very large single-
virtual disk LUNs. Running a virtual disk consistency check on a very large single-virtual disk LUN can take a long
time. By defining the beginning address and ending address of the data blocks, you can reduce the time that a
virtual disk consistency check takes to complete.
Clear Physical Disk Port Statistics
Description
This command resets the statistics for all physical disk ports.
Syntax
clear allPhysicalDiskChannels stats
Parameters
None.
144