Dell PowerVault MD3260i - Manual (Page 205)

Parameters
Parameter Description
allVirtualDisks Deletes all virtual disks in a storage array.
NOTE: Using the allVirtualDisks parameter
deletes virtual disks until all are removed or until an
error is encountered. If an error is encountered, this
command does not attempt to delete the remaining
virtual disks.
virtualDisk or virtualDisks Name of the virtual disk to delete. You can enter more
than one virtual disk name. You must put brackets ([ ])
around the virtual disk name. If the virtual disk name has
special characters, you must also put quotation marks (" ")
around the virtual disk name.
removeDiskGroup Deleting the last virtual disk in a disk group does not
delete the disk group. You can have a standalone disk
group (minus any virtual disks). To remove the standalone
disk group, set this parameter to TRUE. To keep
standalone disk groups intact, set this parameter to
FALSE.
schedule Deletes only the schedule.
Delete Virtual Disk On A Disk Pool
Description
This command deletes either normal or thin virtual disks on a disk pool.
CAUTION: All of the data in the virtual disk is lost as soon as you run this command.
Syntax
delete (allVirtualDisks |
virtualDisk [virtualDiskName] |
virtualDisks [virtualDiskName1 ... virtualDiskNameN] | allVirtual disks)
[removeDiskGroup=(TRUE | FALSE)
retainRepositoryMembers=(TRUE | FALSE)]
force=(TRUE | FALSE)
schedule
retainRepositoryMembers=(TRUE | FALSE)]
205