Dell PowerVault MD3260i - Manual (Page 236)

Parameters
Parameter Description
physicalDisk Specifies the physical disks to assign to the virtual disk
that you want to create. Specify the enclosure ID and slot
ID for each physical disk that you assign to the virtual disk.
Enclosure ID values are 0 to 99. Slot ID values are 0
to 31. You must put brackets ([ ]) around the enclosure ID
value and the slot ID value.
physicalDisk The World Wide Identifier (WWID) of the physical disk
that you want to replace. You can use the WWID instead
of the virtual disk name to identify the virtual disk. Enclose
the WWID in angle brackets (< >).
replacementPhysicalDisk Specifies the physical disks to assign to the virtual disk
that you want to create. Specify the enclosure ID and slot
ID for each physical disk that you assign to the virtual disk.
Enclosure ID values are 0 to 99. Slot ID values are 0
to 31.
Reset iSCSI IP Address
Description
This command resets the IP address for the remote storage array to re-establish connection with the local storage
array. You can use this command to notify the local storage array that the iSCSI IP address of the remote storage array
have changed and need to be updated.
When establishing an remote replication relationship with an iSCSI connection, both storage arrays store a record of the
IP address of the remote storage array of the remote replication configuration. If the IP address of an iSCSI port
changes, the remote storage array that is attempting to use that port encounters a communication error.
The storage array with the changed IP address sends a message to each remote storage array associated with the
remote replication groups that are configured to replicate over an iSCSI connection. Storage arrays that receive this
message automatically update their remote-target IP address.
If the storage array with the changed IP address is unable to send its inter-RAID controller module message to a remote
storage array, the system sends you an alert of the connectivity issue. Use the reset command to re-establish
connection with the local storage array.
Syntax
reset (remoteStorageArrayName="storageArrayName" |
remoteStorageArrayWwid=<wwID>)
iscsiIpAddress
236