Dell PowerVault MD3260i - Manual (Page 288)

Parameter Description
snapshot images for a repository full policy. Use integer
values. The default value is 32.
rollBackPriority Use this parameter to determine whether system
resources should be allocated to the rollback operation at
the expense of system performance. Valid values are
highest, high, medium, low, or lowest. A value of
high indicates that the rollback operation is prioritized
over all other host I/O. A value of lowest indicates that
the rollback operation should be performed with minimal
impact to host I/O.
Notes
You can use any combination of alphanumeric characters, underscore (_), hyphen (-), and pound (#) for the names.
Names can have a maximum of 30 characters.
When you use this command, you can specify one or more of the parameters. You do not, however, need to use all of the
parameters.
Set Snapshot Group Media Scan
Description
This command runs a media scan on a snapshot group.
Syntax
set snapGroup ["snapGroupName"]
mediaScanEnabled=(TRUE | FALSE)
consistencyCheckEnabled=(TRUE | FALSE)
Parameters
Parameter Description
snapGroup The alphanumeric identifier (including - and _) of the
snapshot group on which you want to run a media scan.
Enclose the snapshot group name in double quotation
marks (" ") inside of square brackets ([ ]).
mediaScanEnabled The setting to turn on or turn off media scan for the virtual
disk. To turn on media scan, set this parameter to TRUE.
To turn off media scan, set this parameter to FALSE. (If
media scan is disabled at the storage array level, this
parameter has no effect.)
consistencyCheckEnabled The setting to turn on or turn off consistency checking
during a media scan. To turn on consistency checking, set
288