Dell PowerVault MD3260i - Manual (Page 270)

Parameters
Parameter Description
enclosure Service tag of the RAID enclosure or the expansion
enclosure for which you are setting the enclosure ID. You
must put quotation marks (" ") around the Service Tag.
id Specifies the value for the RAID enclosure or expansion
enclosure ID. Valid values are 0 through 99. You do not
need to put parentheses around the enclosure ID value.
Set Foreign Physical Disk to Native
A physical disk is considered to be native when it is a part of a storage array disk group. A physical disk is considered to
be foreign when it does not belong to a storage array disk group or when it fails to be imported with the physical disks of
a disk group that are transferred to a new storage array. The latter failure creates an incomplete disk group on the new
storage array.
Description
Run this command to add the missing (foreign) physical disks back into their original disk group and to make them part of
the new storage array disk group configuration of the new storage array.
Use this operation for emergency recovery only: when one or more physical disks must be changed from a foreign
physical disk status and returned to a native status within their original disk group.
CAUTION: Using this command for purposes other than what is stated above might result in data corruption or data
loss without notification.
Syntax
set (physicalDisk [enclosureID,slotID] |
physicalDisks [enclosureID1,slotID1 enclosureID2, slotID2...
enclosureIDn,slotIDn]|
allPhysicalDisks) nativeState
Parameters
Parameter Description
physicalDisk or physicalDisks The enclosure and the slot where the physical disk
resides. Enclosure ID values are 0 to 99. Slot ID values
are 0 to 31. Enclose the enclosure ID values and the slot
ID values in square brackets ([ ]).
allPhysicalDisks Selects all the physical disks.
270