Dell PowerVault MD3260i - Manual (Page 178)

Parameter Description
array must be connected through a proper Fibre Channel
fabric or iSCSI interface.
remotePassword The password for the remote storage array. Use this
parameter when the remote storage array is password
protected. Enclose the password in double quotation
marks (" ").
syncInterval Specify the length of time between automatically sending
updates of modified data from the local storage array to
the remote storage array. You can specify the length of
time in minutes, hours, or days.
warningSyncThreshold Specify the length of time to wait until a warning is
triggered for cases in which the synchronization of all of
the virtual disks within the remote replication group takes
longer than the defined time. You can specify the length of
time in minutes, hours, or days.
warningRecoveryThreshold Specify the length of time to wait until a warning is
triggered when the automatic data update for the point-in-
time image on the remote storage array is older than the
defined time. Define the threshold from the end of the
previous update. You can specify the length of time in
minutes, hours, or days.
NOTE: You must set the Recovery Point Threshold to
be twice as large as the synchronization interval
threshold.
warningThresholdPercent Specify the length of time to wait until a warning is
triggered when the capacity of a replication repository
virtual disk reaches the defined percentage. Define the
threshold by percentage (%) of the capacity remaining.
autoResync The settings for automatic resynchronization between the
primary virtual disks and the secondary virtual disks of a
remote replicated pair within a remote replication group.
This parameter has these values:
• enabled—Automatic resynchronization is
turned on. You do not need to do anything further
to resynchronize the primary virtual disk and the
secondary virtual disk.
• disabled—Automatic resynchronization is
turned off. To resynchronize the primary virtual
disk and the secondary virtual disk, you must run
the resume remoteReplicationGroup
command.
178