Rockwell Automation PLC-5 Fieldbus Solutions for Integrated Architecture User Manual - Manual (Page 207)

Publication 1757-UM006A-EN-P - May 2002
Standard Function Block Parameters A-27
Table A.73 LOW_CUT
Mxxx Blocks Table A.74 MANUFAC_ID
Table A.75 MAX_NOTIFY
Length 1
Valid Views VIEW_4
Storage Static
Classification Simple Variable
Description Represents the limit used for the flow sensor input processing by the Analog
Input block, if the Low Cutoff selection is choosen in IO_OPTS. If the calcu-
lated PV falls below this limit, the PV value is set to zero (0).
FF Data Type Float
Range Positive
Usage C/Contained
Length 4
Valid Views VIEW_4
Storage Static
Remarks This function may be used to eliminate noise near zero from a flow sensor.
Classification Simple Variable
Description Defines the manufacturer's identification number. This number is used by an
interface device to locate the DD file for the resource.
FF Data Type Unsigned 32
Range Set by manufacturer
Usage C/Contained
Length 4
Valid Views VIEW_4
Storage Static
Remarks Read Only
Classification Simple Variable
Description Defines the maximum number of unconfirmed notify messages possible.
FF Data Type Unsigned 8
Range Set by manufacturer
Usage C/Contained
Length 1