Frame a, Remove the cover(s) from the drive – Rockwell Automation 23P PowerFlex Digital DC Drive User Manual
Page 369
Rockwell Automation Publication 20P-UM001K-EN-P - July 2014
369
Installing a Communication Adapter
Appendix E
3.
Remove the cover(s) from the drive:
Frame A
a.
Remove the screws that secure the bottom cover to the drive, then slide
the cover down and off the drive chassis.
b.
Press in on the sides at the bottom edge of the top cover and at the same
time pull the cover toward you to pull it partially off the drive chassis.
Next, at the top of the drive, pull the cover forward, away from the drive,
until the pins fit in the keyhole in the top of the cover, then carefully lift
the cover off of the drive chassis.
=
STS
PORT
MOD
NET A
NET B
Disconnect DPI cable.
IMPORTANT
The HIM assembly is connected to the control board by a cable and
therefore will not pull free from the drive until disconnected. See step 4
page
for instructions.
When metal pin fits in keyhole,
lift cover off drive chassis.
STS
PORT
MOD
NET A
NET B