Ac input contactors, Dc output contactors, Dynamic brake resistors – Rockwell Automation 23P PowerFlex Digital DC Drive User Manual
Page 31

Rockwell Automation Publication 20P-UM001K-EN-P - July 2014
31
Installation and Wiring
Chapter 1
When operating a drive with firmware version 1.006 in field weakening mode
with a DC contactor or inverting fault device that is installed in the armature
circuit, see Field Weakening Mode Configuration (v1.006) on page
.
AC Input Contactors
See AC Input Line Reactors and AC Input Contactors on page
for a list of
recommended AC input contactors.
DC Output Contactors
A DC output contactor can be used to connect the output of the armature circuit
to the DC motor. If a DC output contactor is used, an AC input contactor is not
needed.
See Dynamic Brake Resistor Kits and DC Output Contactors on page
list of recommended DC output contactors.
Dynamic Brake Resistors
See Dynamic Brake Resistor Kits and DC Output Contactors on page
list of recommended dynamic brake resistor kits.