Lenze PLC Designer ApplicationTemplate (PLC Designer R3-x) - Manual (Page 6)

About this documentation
6
Lenze · ApplicationTemplate · 1.3 EN - 04/2013
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
1 About this documentation
This documentation describes the operating mode of the Lenze application template
"ApplicationTemplate" which serves as a basis for programming a Lenze automation system
afterwards. The used automation system consists of a PLC for the "Controller-based Automation"
system and drive components which are connected via the bus system.

Tip!
Information and tools regarding the Lenze products can be found in the download area at:
http://www.Lenze.com
This manual is part of the "Controller-based Automation" manual collection. The manual collection
consists of the documents:

Read the mounting instructions supplied with the controller first before you start
working!
The mounting instructions include safety instructions which must be observed!

Note!
This documentation is a supplement to the »PLC Designer« online help.
Documentation/abbreviation Subject
System manuals (SHB) • "Controller-based Automation"
• Visualization
Communication manuals (KHB) • "Controller-based Automation" EtherCAT®
• "Controller-based Automation" CANopen®
• "Controller-based Automation" PROFIBUS®
Software manuals (SW) • Controller
• »PLC Designer«
• »Engineer«
• »VisiWinNET® Smart«
• »Backup & Restore«

Information on the use of the controller beyond the field of "Controller-based
Automation" can be found in the system manuals tailored to the application case.