8 working with the applicationtemplate, Working with the applicationtemplate, 8working with the applicationtemplate – Lenze PLC Designer ApplicationTemplate (PLC Designer R3-x) User Manual
Page 39
Lenze · ApplicationTemplate · 1.3 EN - 04/2013
39
Working with the ApplicationTemplate
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
8
Working with the ApplicationTemplate
This chapter provides information on how to create modular machine functions / machine modules
with the machine module template in the ApplicationTemplate. The MM_EmptyModule machine
module is a template for the creation of individual machine modules.
Programming with the ApplicationTemplate: What has to be done?
Step
Action
Detailed information
1.
Structuring the automation system
• The overall functionality (machine
application) of the automation system is to
be mapped modularly:
One subfunction = one machine module
• In this project phase, programming is not
yet required!
Assign the relative address to the machine modules.
2.
Starting the ApplicationTemplate
Opening the ApplicationTemplate ( 30)
3.
Updating the project (optional)
• Adjust the device information version in the
»PLC Designer« project to the firmware
version of the controller.
• Integrate another controller in the project if
required. The controller included is the
3200 C.
Update the controller in the project (optional) ( 32)
4.
Mapping the actual machine structure in the
»PLC Designer«
Mapping the actual machine structure in the »PLC
•
Adding devices - EtherCAT bus system ( 40)
•
Adding devices - CANopen bus system (optional)
•
Setting of CAN parameters and PDO mapping ( 48)
6.
Creating/integrating individual machine
modules
Creating your own machine modules: Copy/
7.
Integrating devices
Integrating I/O modules of the I/O system 1000 with a
Integrating a module application ( 66)
8.
Going online
9.
Starting the PLC program
Loading and starting the PLC program ( 33)
Carrying out an online change