Lenze PLC Designer ApplicationTemplate (PLC Designer R3-x) - Manual (Page 32)

Opening the ApplicationTemplate
Update the controller in the project (optional)
32
Lenze · ApplicationTemplate · 1.3 EN - 04/2013
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7.2 Update the controller in the project (optional)
Cases in which the project must be updated
The controller in the »PLC Designer« must be updated if ...
• ...the project contains firmware information that is older than the hardware to be used or
• ...a controller other than the integrated 3200 C controller is desired (example: p500).
If the controller is marked with the icon after the project is opened, the device information of
the »PLC Designer« project have to be updated.
Determining the firmware of the controller

How to proceed:
• Use the »WebConfig« to check which firmware is used by the controller to select the
appropriate device information in the »PLC Designer«.
• If the controller must be updated, the dynamic memory settings of the application must be
adapted.
Adapting the memory settings

Highlight the desired controller.
• Execute the Update device command in the context menu.
• Double-click the applicable controller in the Update device dialog window to update the
controller in the Device view:
1. In the context menu of Application, execute the Properties command.
• On the Application build options tab, activate the; Use dynamic memory allocation
option.
• For Maximum size of memory, enter a value of 100000:
• Click OK to confirm.