beautypg.com

Working with the applicationtemplate – Lenze PLC Designer ApplicationTemplate (PLC Designer R3-x) User Manual

Page 44

background image

Working with the ApplicationTemplate

Mapping the actual machine structure in the »PLC Designer«

44

Lenze · ApplicationTemplate · 1.3 EN - 04/2013

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

2. Set the baud rate via the CANbus tab.

Note: The value of the transfer rate set in the »PLC Designer« overwrites any existing

transfer values of the devices (set via »WebConfig«/»Engineer«).

3. In a CANopen network, set the same baud rate for all nodes.

4. Use the

Add Device command to extend the control configuration by

"CANopen

Manager".

See also other documents in the category Lenze Software: