Lenze PLC Designer ApplicationTemplate (PLC Designer R3-x) - Manual (Page 30)

Opening the ApplicationTemplate
30
Lenze · ApplicationTemplate · 1.3 EN - 04/2013
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7 Opening the ApplicationTemplate
The ApplicationTemplateCounter includes a sample program with three machine modules and a
predefined visualization. The sample program serves to test the basic functions of the
ApplicationTemplate. The sample program in the ApplicationTemplateCounter ( 134)
Standard procedure
The main steps are summarised in the following table:
Detailed commissioning steps
The following section describes the individual commissioning steps in detail.
Follow the instructions specified step by step to commission your automation system.
Step Action
1. Create a new project - open the ApplicationTemplate ( 31)
2. Update the controller in the project (optional) ( 32)
3. Going online ( 33)
• Compiling the project data ( 33)
• Transferring the project to the control - "Log in" ( 33)
4. Loading and starting the PLC program ( 33)
5. Getting started - operating the ApplicationTemplate ( 35)

Further information on the parameter setting and configuration of the respective bus
system can be found in the following communication manuals (KHB):
• Communication manual EtherCAT: "Controller-based Automation" EtherCAT
• Communication manual CANopen: "Controller-based Automation" CANopen
• Communication manual PROFIBUS: "Controller-based Automation" PROFIBUS