Lenze PLC Designer ApplicationTemplate (PLC Designer R3-x) - Manual (Page 112)

The L_EATP_ApplicationTemplate library
Automatically generated functions
112
Lenze · ApplicationTemplate · 1.3 EN - 04/2013
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
11.1.2 GetCompany (automatically generated by »PLC Designer«)
The function provides the name of the company that has created the library.
Outputs
11.1.3 GetNumberProperty (automatically generated by »PLC Designer«)
The function provides numerical project information of the library. (Currently, no numerical project
information is used).
Inputs
Outputs

Note!
This function must always be used with the corresponding name area of the related
library. (for instance IOStandard.GetCompany())
GetCompany
GetCompany ⎯ WSTRING
Identifier/data type Information/possible settings
GetCompany
WSTRING
Name of the company that created the library.

Note!
This function must always be used with the corresponding name area of the related
library. (for instance IOStandard.GetNumberProperty(stKey))
GetNumberProperty
WSTRING ⎯ stKey GetNumberProperty ⎯ DINT
Identifier/data type Information/possible settings
stKey
WSTRING
Key of the project information
Identifier/data type Information/possible settings
GetNumberProperty
DINT
Value of the project information