Configuring hp-ux version 9.x – Apple LaserWriter 12/640 PS User Manual
Page 89
89
Setting Up the Printer for UNIX Users
4
Make sure the following entry is in the
/etc/services
file:
printer 515/tcp spooler
5
Start
inetd
by typing the following command at the UNIX prompt:
/etc/inetd -c
6
Repeat the steps in “Configuring HP-UX Version 8.07.”
Configuring HP-UX version 9.x
You must configure the printer as a remote printer, not as a network printer.
1
Log in to the system console as
root
.
The System Administration Manager (SAM) uses a screen-oriented interface
that works best at the console.
2
Assign an IP address and IP name to the printer, as described in “Step 3: Assigning an
IP Address to the Printer,” earlier in this chapter.
3
Make sure the printer’s IP name and IP address are entered in the
/etc/hosts
file.
4
Run the SAM utility by typing
sam
at the UNIX prompt.
5
Select the following options, in order, from the SAM menu:
Printers and Plotters
Printers/Plotters
Actions
Add a Remote Printer/Plotter
(Do not select “Add a Network
Printer.”)
A form appears for you to define a remote printer.
6
Enter information into the remote printer form as follows:
m
Printer name
Type the local queue name users will use as the name for
the printer.
m
Remote system name
Type the IP name assigned to the printer as described
in “Step 3: Assigning an IP Address to the Printer,” earlier in this chapter.
m
Remote printer name
Type
raw