beautypg.com

Apple LaserWriter 12/640 PS User Manual

Page 247

background image

The printer administrator forgot the password for the TCP/IP Printer Configuration Utility.

See the service information that came with your printer to learn how to get in
touch with Apple.

Sometimes printing the first page takes longer than I expect.

The LaserWriter 12/640 PS automatically goes into an energy-saving mode
after it’s been idle for a while. When you print while it’s in this mode, the
printer takes about a minute to warm up before it can print the first page.

The RARP server is not responding.

If you chose to use a RARP server to assign the printer’s IP address while
setting up the printer, but the server is not responding, follow these steps
in order:

m Verify that the

rarpd

daemon is running on the server. On many

UNIX systems, you can verify this by typing

ps -e

or

ps -ax

at the

UNIX prompt on the server. If the daemon isn’t running, type

/usr/etc/rarpd -a

to start the daemon.

m Make sure that the server running RARP is on the same subnet as

the printer.

m Check the

/etc/ethers

file to verify that it contains the correct

Ethernet address and hostname.

m Check the

/etc/hosts

file to verify that it contains a valid IP address

and the same hostname as in the

/etc/ethers

file.

m Turn the printer off and then back on.

The BOOTP server is not responding.

If you chose to use a BOOTP server to assign the printer’s IP address while
setting up the printer, but the server is not responding, follow these steps
in order:

m Make sure that the server running BOOTP is on the same subnet as the

printer or that BOOTP is properly configured to run on multiple subnets.

247

Fixing Other Problems