Communication settings – Apple LaserWriter 12/640 PS User Manual
Page 321
Communication settings
The following table shows the default communication settings. For
information about using the communication switch to adjust communication
settings, see “Adjusting Communication Settings” in Chapter 1. To change or
view the current communication settings, use the Apple Printer Utility on
Mac OS–based computers or the Apple LaserWriter Utility for Windows on
IBM PC or compatible computers (see Appendix A).
Normal (in) switch position
These settings can be changed to the following modes:
Port
Network Protocol
Mode
Default
LocalTalk
LocalTalk
PostScript
PostScript
Ethernet
EtherTalk
PostScript, Off
PostScript
Netware
PostScript, PCL5, AutoSelect, Off
AutoSelect
TCP/IP
PostScript, PCL5, AutoSelect, Off
PostScript
Parallel
TBCP
PostScript, PCL5, AutoSelect, Off
AutoSelect
Normal
PostScript, Off
PostScript
Raw
PostScript, PCL5, AutoSelect, Off
AutoSelect
Reset (out) switch position
When the communication switch is in the Reset (out) position, the following
values are used:
Port
Network Protocol
Mode
LocalTalk
LocalTalk
PostScript
Ethernet
EtherTalk
PostScript
NetWare
AutoSelect
TCP/IP
PostScript
Parallel
Parallel
AutoSelect (raw protocol)
Note: When the communication switch is in the Reset (out) position, a
startup page is printed each time the printer is turned on and the Extended
Job Status settings are removed.
321
Technical Information