Apple Shake 4 Tutorials - Manual (Page 57)

Tutorial 2 Intermediate Skills 57
To load the mitosis node into the Parameters tab, do one of the following:
m In the Node View click the right side of the mitosis node.
m In the Time Bar, click the parameters indicator on the mitosis bar.
The mitosis parameters appear in the Parameters tab.
Under the Source subtab , the firstFrame parameter is set to 1 and the lastFrame
parameter is set to 35. These are the source frames read from the image sequence
on disk.
Click the Timing subtab and you’ll see how the clip lines up with the Time Bar frames.
The inPoint is set to 1 and the outPoint is set to 36, which is one frame after the last
frame in your clip.
Suppose you want to change where the clip begins in the Time Bar, but you don’t want
to change the number of frames used from the clip.