SkyTrak 6036 Service Manual User Manual

Page 93

3.53

Model 6036 Legacy

Boom

10. Repeat the entire “Extend Chain Removal and

Installation” section. Starting with Step 4 of the
“Extend Chain Removal” and continuing on to Step 9
of the “Extend Chain Installation,” to remove and
replace the left side extend chain.

11. At the rear of the boom, tighten the two elastic

locknuts (Fig. 3-117, 1) on the extend chain clevis’
until the amount of threads protruding beyond each
elastic locknut is the same as the measurement
recorded during removal of the extend chains.

Figure 3- 117 Extend Chain Adjustment Locknuts

12. Check and adjust the extend chain tension. (Refer to

Section 3.3.7, c. “Boom Chain Tension Check.”)

13. Install the rear cover (Fig. 3-118, 1), by inserting the

capscrew (2) at the top of the cover into the hole (3)
in the top of the boom. Secure the rear cover using
one thumbscrew (4), one internal-tooth lockwasher (5)
and one flat washer (6).

Figure 3- 118 Install the Rear Cover on the Outer Boom

MA6620

MA6420