SkyTrak 6036 Service Manual - Manual (Page 365)

9.13 Model 6036 Legacy
Electrical System
2. The neutral start relay (Fig. 9 -10, 1) is located at the
fuse block and is mounted behind the right side
console access panel (Fig. 9 -9, 1). To gain access,
remove the screws (2) that secure the right side
panel in place.
Figure 9-9 Remove the Right Side Console Access Panel
to Gain Access to the Electrical Fuse and Relay Panel
3. Remove the neutral start relay (Fig. 9 -10, 1) from
the fuse block.
Figure 9-10 The Fuse and Relay Panel is Mounted Under
the Right Side Control Console
4. Apply 12 volts to terminal 86 (Fig. 9-11, 1 and
(Fig. 9 -12) and attach the ground (-) probe to
terminal 85 (2) ground. An audible click should be
heard indicating that the relay is functioning properly.
Figure 9-11 Neutral Start Relay Terminals
Figure 9-12 Neutral Start Relay Internal Components
Note: To test diodes in an alternator, set your DMM dial
on the R x 1 setting and connect one lead to the
common side of the diode. Connect the other lead to the
other side of any of the remaining diodes. Note the
reading on the DMM. Reverse the leads and note
reading. Your DMM should indicate a high or infinite
resistance (no meter movement) when connected one
way and a low reading when connected to the other. If
both readings are high or infinite, the diode is open. If
both readings are low, the diode is shorted. Repeat test
on remaining diodes. If any diodes are shorted or open,
replace the alternator.
OH2430
2
1
Main
Light Switch
Relay
Instrument
Panel
Horn/Heater
Steer Select
Switch
Opt.
Washer/Wipers Lights
Transmission
Headlight
Switch
Relay
Park Brake
Disengage
Relay
Light
Switch
Relay
Neutral
Start
Relay
Backup
Relay
7.5
30 10
10
10
10
7.5
40
MA7900
1
86
85
30
87
87A
1
2
MN1820
87A
87
86 85
30
MT3140