SkyTrak 6036 Service Manual - Manual (Page 381)

9.29 Model 6036 Legacy
Electrical System
If OK
Not
OK
Check for battery voltage at
circuit 9 (GRY/BLK) at
steer select manifold valve
solenoid. Check 2C (BLK)
ground connections.
With steer select switch
in 4-wheel steer mode,
only 2-wheel steering
is active.
See Section 8.8, “Hydraulic
Circuits and Troubleshooting”
for additional information.
Check steer select manifold
valve solenoid resistance.
Should have 5 to 7 ohms
resistance.
If OK
Check 10-amp steer
select fuse.
Before troubleshooting any
electrical circuit, ALWAYS
begin by checking the
following:
1. All connections relating
to circuit are clean and
tight.
Replace steer select manifold
valve solenoid.
If OK