SkyTrak 6036 Service Manual User Manual

Page 279

8.63

Model 6036 Legacy

Hydraulic System

2. A special steel sleeve made from 1-1/2" (38,1 mm)

diameter round steel bar stock, 4-5/8" (117,5 mm) in
length as shown in Fig. 8-30. This sleeve is used to
insert the drive shaft through the lip seal without
causing damage.

Figure 8- 30 Special Steel Sleeve Dimensions

3. A lip seal installation bar made from 1-3/4" (44,5 mm)

diameter round steel bar stock, 2" (50,8 mm) long.
Grind the edges slightly to form the tool.

4. The following tools will also be required:

• Arbor Press

• Awl

• Clean, Lintless Cloths

• Metal Deburring Tool

• Machinist’s Hammer

• Soft Hammer

• Non-Hardening Sealant (Permatex

Aviation

Form-A-Gasket No. 3 or equivalent)

• Medium-Grit Carborundum Stone

• Oil and Grease

• Snap-Ring Pliers

• Scale, 1/32" (0,79 mm) or

1/64" (0,40 mm) Graduations

• Small Screwdriver

• Torque Wrench

• Vise with 8" Minimum Open Spread

c. General Repair Precautions

1. To facilitate repair of the pump and before any work

is done, read and understand all of the steps used in
the disassembly and assembly instructions.

2. Perform procedures in a clean area. It is important to

service hydraulic equipment in as clean an
environment as possible.

3. If it becomes necessary to pry sections apart, be

extremely careful to avoid damaging the finely
machined surfaces. Excessive force used while
prying can result in misalignment and serious
damage to parts.

4. Match-mark the exterior surfaces of any housings

before separating the components. Use the marks to
return components to their original locations during
assembly.

5. Gears are closely matched sets that wear in

together. Keep gears together as sets when
removing them from a unit. Handle gears with care
to avoid damaging the journals or teeth. Avoid
touching gear journals. Always replace matched
parts as a set.

6. To help prevent damage, DO NOT grip machined

surfaces in a vise.

7. If parts are difficult to fit together during assembly,

tap gently with a soft hammer. NEVER use an iron or
steel hammer to tap parts.

8. NEVER hammer bushings into bores. Use an arbor

press and bushing drivers of appropriate sizes to
install bushings.

C RADIUS

0.015" X 45°

CHAMFER

A = 3-3/8"
B = 4-1/2"
C = 9/16" R
D = 1.065 PLUS 0.000, MINUS 0.002"
E = 1.002 PLUS 0.002, MINUS 0.000"

1/4" DIAMETER DRILL

THROUGH HOLE

MA0821