SkyTrak 6036 Service Manual - Manual (Page 47)

3.7 Model 6036 Legacy
Boom
15. With optional auxiliary hydraulics: Inside the inner
boom, remove the two capscrews (Fig. 3-8, 1), two
lockwashers (2) and two flat washers (3) holding the
clamp cover (4) and stack clamps (5) to the floor of the
inner boom. Remove the clamps from the inner boom.
Figure 3-8 Remove the Attachment Tilt and Auxiliary
Hydraulics Hose Clamps from the Inner Boom
16. Pull the free ends of the attachment tilt hoses
(Fig. 3-9, 1) and (optional) auxiliary hydraulic hoses
(2) from inside the inner boom, and out the rear of
the boom (3). Allow the hoses to hang from the rear
of the boom.
Figure 3-9 Pull the Attachment Tilt and Auxiliary
Hydraulics Hoses from the Inner Boom
Note: Record the location of the shoulder bolt
(Fig. 3 -10, 2) to ensure correct installation.
17. At the rear of the outer boom, locate the end of the
retract chain (Fig. 3-10, 1). Remove the elastic
locknut (2) and shoulder bolt (3) holding the retract
chain clevis (4) to the anchor plates (5). Save the
shoulder bolt. Discard the locknut. Remove the
retract chain from the anchor plates. Allow the retract
chain (1) to hang out the rear of the boom.
Figure 3-10 Remove the Retract Chain Anchor Plates
from the Retract Chain
MA6600
4
2
1
3
5
MA6610
2
1
3
2
MH2340
2
4
1
3
5