SkyTrak 6036 Service Manual User Manual

Page 119

4.15

Model 6036 Legacy

Cab and Covers

12. Install the lower (Fig. 4-25, 1) and upper (2)

transmission covers; secure using six hex-head
capscrews, six lockwashers and six flat washers (3).

Figure 4-25 Install the Upper and Lower

Transmission Covers

4.3.7

Auxiliary Hydraulics Joystick
Assembly Replacement

a. Auxiliary Hydraulics Joystick Removal

1. Park the vehicle on a firm, level surface. Allow

sufficient overhead and side clearance for cab
removal. Level the vehicle, ground the attachment,
place the travel select lever in the (N) NEUTRAL
position, place the neutral lock lever in the (N)
NEUTRAL LOCK position, engage the parking brake
switch and shut the engine OFF.

2. Place an Accident Prevention Tag on both the

ignition key switch and steering wheel, stating that
the vehicle should not be operated. (Refer to Section
1.5, “Accident Prevention Tag Usage.”)

3. Unlock and open the rear door. Allow the engine and

hydraulic fluid to cool.

4. Disconnect the battery negative (-) cable at the

battery negative (-) terminal.

5. Remove six hex-head capscrews, six lockwashers

and six flat washers (Fig. 4-25, 3) securing the upper
(2) and lower (1) transmission covers to the frame.
Remove the covers.

Note: Record the distance (Fig. 4 -26, 1) from the outer
jam nut to the end of the ferrule on cable, to ensure
correct adjustment when reinstalling cable.

6. Disconnect the boom auxiliary hydraulics control

cable:

a. Remove the spring pin and anchor pin (Fig. 4-

26, 2). Save the spring pin and anchor pin for

installation.

b. Loosen and remove the inner jam nut (Fig. 4-26, 3),

and remove the auxiliary hydraulics control cable
(4) from the bracket. Save the jam nut for
installation.

c. Route the cable through the opening at the

bottom of the frame.

Figure 4-26 Disconnect the Auxiliary Hydraulics Control

Cable at the Main Control Valve

7. Remove four button-head screws (Fig. 4-24, 4) and

remove the console panel (3).

MA8620

MA8490